Liquid Plumr Power Jet Clog Remover

Ingredients from the label

Directions from Packaging

This is a single-use product. Follow all steps to ensure best results. Unlock Cap: Hold base ring of cap, squeeze both tabs on side of top cap, and turn until lines match up. Do not remove cap. Avoid accidents by using immediately. Cover Openings: Cover overflow vent with damp sponge or cloth to seal tightly. For side-by-side sinks, seal drain and overflow wents in second sink as well. Kitchen sinks and showers may not have overflow vents. For best results: Fill drain pipes with a little water by running tap in sink or tub for a few seconds. Blast Clog: Place cap over drain and ensure good seal. While keeping overflow vent tightly covered, push can down firmly and hold for at least 3 seconds or until all pressure is released and can is empty. Discard can. Flush with hot water. Do not useon toilets. Special Circumstances: SituationActionCap does not fit over stopper. Remove stopper. Mesh grating. Remove grating. Drain opening larger than cap. Wrap damp cloth around cap

Warnings

Warnings: Contents under pressure. Do not use with other drain cleaners or household chemicals, or in clogged drains where they are still present. Splashback of other products may occur that can cause burns to skin and eyes. Do not puncture or incinerate container. Do not expose to heat or store at temperatures above 120 F since container may burst. Avoid Accidents: Use product immediately upon unlocking. Keep out of reach of children. Intended for use only on plumbing that is properly designed and installed, and undamaged. Do not remove cap.