Mr. Clean Antibacterial Multi-Surface Spray, Febreze Citrus and Light [DISCONTINUED]

Ingredients from the label

Active Ingredients: n-Alkyl (C14-60%, C16-30%, C12-5%, C18-5%, Dimethyl Benzyl Ammonium Chloride 0.05%, n-Alkyl (C12-68%, C14-32%) Dimethyl, Ethylbenzyl Ammonium Chloride 0.05%, Other Ingredients 99.90%, Total: 100.00%

Directions from Packaging

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Directions: 1. Turn nozzle to On. 2. Spray 6-8 inches from surface. 3. Wipe dry with paper towel or lint free cloth. Do not breathe spray. To Sanitize/Disinfect: For heavily soiled areas, a precleaning is required. For hard, nonporous surfaces, spray until thoroughly wet. To Sanitize: let stand 5 minutes before wiping. To Disinfect: let stand for 10 minutes before wiping.

Warnings

KEEP OUT OF REACH OF CHILDREN CAUTION: SEE BACK PANEL FOR PRECAUTIONARY STATEMENTS AND FIRST AID. **A potable water rinse is required for surfaces in direct contact with food. Do not use on drinking glasses, dishes and utensils. PRECAUTIONARY STATEMENTS: HAZARDOUS TO HUMANS AND DOMESTIC ANIMALS. CAUTION: causes eye irritation. Avoid contact with eyes or clothing. Wash thoroughly with soap and water after handling. FIRST AID: IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. IF IN EYES:Hold eye open and rinse slowly and gently with water for 15-20 minutes. remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a Poison Control Center or doctor for treatment advice. Have the product container or label with you when calling a Poison Control Center or doctor or going for treatment. PHYSICAL OR CHEMICAL HAZARDS: Do not use or store near heat or open flame. STORAGE/DISPOSAL: Store in original container in areas inaccessible to children. Nonrefillable container. Do not reuse or refill this container. Wrap container and put in trash or offer to recycling if available. Note: Will not harm most washable surfaces. However, on painted surfaces and wall coverings, test a small area before use. If applied to sluminum, wipe dry immediately. repeated use on copper or brass may discolor these surfaces.