HOME / Disinfectant / Good & clean disinfectant wipes
Good & Clean Disinfectant Wipes
Good & Clean Disinfectant Wipes
WHERE TO BUY
CATEGORY
DisinfectantBRAND
Good & CleanDATA LAST UPDATED
September 10, 2012
Ingredient concerns
See how this product scores for common concerns.
Health Concerns
-
No DataAsthma / Respiratory
-
No DataSkin Allergies & Irritation
-
No DataDevelopmental & Reproductive Toxicity
-
No DataCancer
-
No DataEnvironment
Ingredient scores
Ingredient Disclosure: poor
Ingredients are scored based on their formulation and concentration in this product. Click on an ingredient for more information.
Ingredients from the label
Directions from Packaging
To open package: Lift tab at front of lid to open. Pull up corner of center sheet and thread through dispenser slit in lid. Pull out exposed wipe at a 45 degree angle and snap off. The next wipe is ready for dispensing. Close lid to retain moisture. Dispose of used wipes in trash. Do not flush. It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Cleaning: Use one wipe to completely remove all loose debris from surfaces to be treated. Disinfecting: To disinfect hard, non-porous surfaces, thoroughly wet the surface to be treated. Treated surface must remain visibly wet for disinfecting. Use enough wipes for treated surface to remain visibly wet for 5 minutes. For heavily soiled surfaces, clean before following disinfecting instructions. Allow surfaces to air dry. This product is an effective disinfectant against Escherichia coli (E. coli) 0157:H7, Pseudomonas aeruginosa, Salmonella enterica, Staphylococcus aureus (Staph) and Streptococcus pyogenes (Strep). Virucidal activity: This product is an effective virucide on hard, non-porous surfaces against Influenza A2/Japan, Herpes Simplex Virus 1 and Herpes Simplex Virus 2 when the treated surface is allowed to remain wet for 5 minutes. Allow surfaces to air dry. Sanitizing/deodorizing: To sanitize/deodorize hard, non-porous surfaces; wipe surface using enough wipes to allow treated surface to remain wet for 15 seconds for Staphylococcus aureus (Staph), Klebsiella pneumoniae, Listeria monocytogenes, Escherichia coli (E. coli) 0157:H7 and 60 seconds for Campylobacter jejuni. Let surface dry. For highly soiled surfaces, clean excess dirt first. For surfaces that may come in contact with food, a potable water rinse is required For plastic and painted surfaces, spot test on an inconspicuous area before use This product will not harm most surfaces including acrylic, fiberglass and vinyl.
Warnings
KEEP OUT OF REACH OF CHILDREN.Do not use on unpainted wood. Not for personal cleansing. This is not a baby wipe! Do not flush in toilet. Hazards to humans and domestic animals. CAUTION: Causes moderate eye irritation. Avoid contact with eyes or clothing. Wash thoroughly with soap and water after handling. FIRST AID: Have the product container or label with you when calling a poison control center or doctor, or going for treatment. IF IN EYES: Hold eyes open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses if present, after the first 5 minutes, then continue rinsing. Call a poison control center or doctor for treatment advice. Do not contaminate water, food or feed by storage or disposal. CONTAINER STORAGE/DISPOSAL: Store in an area inaccessible to children. Dispose of wipe in trash after use. Tightly close lid between uses to retain moisture. Do not reuse empty container except with refill, otherwise rinse thoroughly and discard in trash..
This product is not certified as a green cleaner.
EPA registered pesticide product
Pesticide products registered for use in the United States
Web: http://www.cdpr.ca.gov/docs/label/labelque.htm
Unknown:
Leading international certifiers PETA and Leaping Bunny have no information concerning this company’s use of animal testing.