HOME / Floor Cleaner / Clorox readymop advanced floor cleaner
Clorox ReadyMop Advanced Floor Cleaner
Clorox ReadyMop Advanced Floor Cleaner
WHERE TO BUY
CATEGORY
Floor CleanerBRAND
CloroxDATA LAST UPDATED
September 10, 2012
Ingredient concerns
See how this product scores for common concerns.
Health Concerns
-
SOMEAsthma / Respiratory
-
SOMESkin Allergies & Irritation
-
MODERATEDevelopmental & Reproductive Toxicity
-
MODERATECancer
-
MODERATEEnvironment
Ingredient scores
Ingredient Disclosure: some
Ingredients are scored based on their formulation and concentration in this product. Click on an ingredient for more information.
F |
SURFACTANTS
|
|
||||
|
F |
CLEANING AGENT
|
|
||||
|
D |
FRAGRANCE
|
|
||||
|
D |
POLYAMINOPROPYL BIGUANIDE
|
|
||||
|
C |
PROPYLENE GLYCOL PROPYL ETHER
|
|
||||
|
C |
ALKYL GLUCOSIDES AND POLYGLUCOSIDES
|
|
||||
|
B |
ISOPROPYL ALCOHOL
|
|
||||
|
A |
WATER
|
|
Ingredients from the label
ACTIVE INGREDIENT: Poly(hexamethylenebiguanide) hydrochloride.... 0.10% OTHER INGREDIENTS:................................99.90% TOTAL: ................................................100.00%
Directions from Packaging
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Removing the Cleaner Bottle: 1. Remove bottle by pulling straight up. 2. Slide nozzle back off holder (located on mophead or pole, depending on model). 3. Unscrew bottle connector from old bottle. Note: Nozzle and connector may drip a little, but cleaner will not harm colored surfaces or fabrics. Attaching the Cleaner Bottle: 1. Remove cap from new bottle; then tightly screw bottle connector to bottle. 2. Insert bottle upside-down into bottle holder with front label facing out; push down until bottle clicks in place. 3. Slide nozzle back on holder (located on mophead or pole, depending on model). To clean: Pull trigger to dispense liquid. While mopping, spread liquid uniformly over floor with pad. To disinfect and kill germs* on linoleum, vinyl and glazed ceramic floors: Pull trigger and dispense enough liquid to spread uniformly over the floor while mopping. Treated surface must remain visibly wet for 5 minutes before air drying. This cleaner is a specially designed, no-mixing, no-rinsing solution for use with the Clorox ReadyMop Mopping System. Use of any other cleaning solution not certified by the Clorox ReadyMop Mopping System (including other Clorox products) may cause clogging or other damage to the mopping system and may void your limited warranty. Note: Not recommended for use on visibly worn, unsealed, unfinished, waxed or oiled wood floors. If uncertain about your wood floor's finish, test an inconspicuous area and avoid prolonged contact of the cleaner on the floor surface. Use the specially designed Clorox ReadyMop Absorbent Mopping Pads to dry wood floors thoroughly after 30 seconds.
Warnings
KEEP OUT OF REACH OF CHILDREN. DO NOT REFILL BOTTLE OR MIX WITH ANY OTHER CLEANING SOLUTION. ATTENTION: While removing or attaching nozzle, hold mop pole securely to prevent it from falling. If pole falls, fingers may be pinched in opening on mophead. Avoid Accidents: Floors may be slippery when wet. FIRST AID: Call a poison control center or doctor for treatment advice. Have the product container or label with you when calling a poison control center or doctor or going for treatment. Clorox Information Line: 1-877-276-6725.
This product is not certified as a green cleaner.
EPA registered pesticide product
Pesticide products registered for use in the United States
Web: http://www.cdpr.ca.gov/docs/label/labelque.htm
PETA Cruelty-free Companies
Companies that join the "Caring Consumer" program of People for the Ethical Treatment of Animals, a leading international animal rights advocacy organization, attest that "neither they nor their ingredient suppliers conduct or commission any animal tests on ingredients, formulations or finished products, and that they pledge not to do so in the future."
LEARN MORE ON PETA.ORG